TIDM-02013: TIDM-02013

Bosco N

Prodigy 70 points

Part Number: TIDM-02013
Other Parts Discussed in Thread: C2000WARE

Hi,

The TIDM-02013 ref design is for Single-phase 7.4KW.

I want to design a 15 kW single-phase system.

Is it possible to support us?

over 1 year ago

0 Srikanth Yerra over 1 year ago

TI__Intellectual 1400 points

Hi Bosco,

May I know if your question is about requesting support for the 15 kw power converter design?

Thanks

Srikanth

0 Bosco N over 1 year ago in reply to Srikanth Yerra

Prodigy 70 points

Hi Srikanth,

Thanks for the reply.

I need similar design as TIDM-02013(Single-phase 7.4KW).

with specification, which can support 15KW.

Requirement:

Input= 230Vac

output= 400Vdc @ 15KW

Regards

Bosco

0 Srikanth Yerra over 1 year ago in reply to Bosco N

TI__Intellectual 1400 points

Hi Bosco,

You can refer to the TIDM-02013 code for Firmware development and can reach out to us for any additional support. It's available at C:\ti\c2000\C2000Ware_DigitalPower_SDK_4_04_00_00\solutions\tidm_02013. Mean while we will look at the possibilities to support your 15 kw hardware design.

Thanks

Srikanth

0 Bosco N over 1 year ago in reply to Srikanth Yerra

Prodigy 70 points

Hi Srikanth,

Thanks. Im going through it. Will reach out in case of any support.

Also pl., parallely guide on the hardware part.

Regards

Bosco

0 Brent McDonald over 1 year ago in reply to Bosco N

TI__Intellectual 1665 points

Hi, Bosco,

If you have a specific question on the design I can see what I can do to answer it. However, if you are looking for TI to assist in the hardware development of a full design, you will need to work with your local FAE to determine if this level of support is possible.

Thanks and best regards,

Brent

0 Bosco N over 1 year ago in reply to Brent McDonald

Prodigy 70 points

Hi Brent,

Thanks for your reply.

I just need the calculations to achieve my requirement(Input= 230Vac, output= 400Vdc @ 15KW) . In the present design TIDM-02013(Single-phase 7.4KW).

The rest I will take care

Thanks

Bosco

0 Brent McDonald over 1 year ago in reply to Bosco N

TI__Intellectual 1665 points

Hi, Bosco,

I don't have a generic calculator for a design like this.

If you need a detailed electrical design I'll need you to work through your local FAE to see if we can provide that level of support.

Thanks and best regards,

Brent

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Power management

Power management forum

TIDM-02013: TIDM-02013