LM61435-Q1: Lower Iq at sleep mode

Nikola Zlatanovski

Part Number: LM61435-Q1

Hello!

A customer wants to know if the LM61435-Q1 is able to not go above 20uA Iq at 3V3 output off of a 13.4V battery when it is always enabled, as the datasheet only gives the following:

Let me know if there are any clarifications I need to make.

Thank you so much!

Nikola

over 1 year ago

0 Ridge Lahti over 1 year ago

TI__Mastermind 18715 points

Hi Nikola,

The non-switching quiescent current is used to spec the current draw in-between switching bursts. With always being enabled and in regulation, you would need to calculate your input current using:

Do you know your load draw during the sleep mode?

Best regards,

Ridge

0 Nikola Zlatanovski over 1 year ago in reply to Ridge Lahti

TI__Prodigy 305 points

Hi Rigde and thank you for your response!
I think I was confused by the customers ask so here is a clarification:

When Harman's module is in sleep mode the regulator is still on. the output of the buck is ~20mA which is drawn by the IOC, so ~5uA off battery is going to the load.
We need to understand what the Iq is of the Buck with current not going to the load.

Let me know if I need to reclarify!

Thank you,
Nikola

0 Ridge Lahti over 1 year ago in reply to Nikola Zlatanovski

TI__Mastermind 18715 points

Hi Nikola,

The Iqvin with Vout regulated to 3.3V and no load is approximately 7uA. See Section 7.7 of the device datasheet.

Best regards,

Ridge Lahti

Power management

Power management forum

LM61435-Q1: Lower Iq at sleep mode