Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 175 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM27761: LM27761DSGR has large output ripple

jeno.zhang
Expert 2395 points
Part Number: LM27761

Hi，

The output ripple of LM27761DSGR is relatively large, and currently the peak to peak value tested is approximately 64mV; The current output voltage is -5V; Actually, around -4.9V, adding a capacitor at the output end of LM27761DSGR, 10uF, has improved to around 53mV. Is there any good way to do this? The waveform diagram and schematic diagram are as follows;

Thanks!