Other Parts Discussed in Thread: BQSTUDIO
we use in our project the bq24192 as a charger for 1Cell-LiIon Battery.
I set externally at ILIM Pin a resistor (R=180 Ohm) to set the charging current to approx. 3A.
When i connect an ext. power adapter with 5V a charging current of approx. 1.1A is used. I tried to change the charging current in the edit field ICHGto a value higher than 1.1A but without success. Any value under 1.1A will be accepted but higher not.
Can someone tell me what I'm doing wrong?
Here are my settings :