• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 128 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS548C26: Questions of DRV2603

Jimmy Lai
Expert 6845 points
Part Number: TPS548C26

Dear Team,

I have a question need to check with you.

 

According to Webench suggest schematic, what is the Cnoise is used for?

I saw the Cnoise can be de-pop on other project of our team.

So I’m checking with you about Cnoise is necessary or not?

If it is de-pop, will the action cause another side effect?

Many Thanks,

Jimmy

  • 0
    TI__Expert 4985 points

    Hi Jimmy,

    A response for this will be posted next week. Please expect a delay due to the holidays.

    Thanks,

    Calan

  • 0
    TI__Expert 7860 points

    Hi Jimmy,

    The Cnoise can also be called the feedforward cap, or C_FF. 

    Typically, it is used to improve transient performance or enhance stability of higher VOUT rails.

    If you fill in the device calculator: TPS548C26-CALC Calculation tool | TI.com. On line 111 it will tell you if a CFF is recommended or not, then it will help you calculate the desired CFF.

    If the C_FF is not needed, it is sometimes handy to have it de-pop on the PCB in case you want to "tweak" the compensation to improve transient performance/stability after the PCB is created.

    Thanks,

    Joseph