• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 93 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5060:Overcurrent power is cut off.

Jeon Eun Bin
Prodigy 20 points
Part Number: LM5060

Hello,

I'm working on creating a circuit using LM5060 to control the on/off state of a battery.

However, the output is being cut off at a 14A load, and I need the circuit to support a maximum of 19A.

I'm not sure where the issue might be.

Thanks.

  • +1
    TI__Guru** 102711 points

    Hi Jeon,

    Welcome to E2E!

    Can you increase R3 and check. These component values (Rs and Ro) has to be sized to meet the target overcurrent protection threshold (OCP). Alternatively, you can use LM5060-Q1 design calculator to check the OCP range and adjust accordingly.

    BR,

    Rakesh