• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 64 subscribers
  • Views 130 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC27424: Exposed of bonded wire and anomaly on solder pad.

Calvin Goh
Prodigy 200 points
Part Number: UCC27424

We have recently bought 22,500pcs of UCC27424DGNR with DC2229 and DC2231. As we were doing checks prior to mounting on our PCB boards, our QC team observed exposed of bonded wire seen on top of the package as well as anomaly on solder pad (Mold resin). 

Could you please help check and advise if below photo presented as observed exposed of bonded wire seen on top of the package as well as anomaly on solder pad (Mold resin) can meet TI standard on the condition the parts pass soldering, X-Ray, Decap testing? 

 Thanks

Calvin

  • 0
    TI__Expert 6735 points

    Hi Calvin,

    Thank you for providing the pictures. I am currently looking into this issue and will get back to you in the next couple days.

    Thanks,
    Rubas

  • +1 in reply to Rubas Khalid
    TI__Expert 6735 points

    Hi Calvin,

    Thanks for your patience. I have received info that the anomaly on the top of the package could possibly be exposed metal, but it is not clear enough to identify for sure. If possible, can you send pictures that are closer up and clearer of that mark circled in red in your second picture? 

    That part should have not passed, so it most likely went through by mistake. The anomaly on the solder is pad shouldn't be a concern, though.

    Thanks,
    Rubas