TL1431-SP: Total Accuracy

Kyle Ryan

Part Number: TL1431-SP

If designing for worst case, is the total accuracy of the part just the stated Vi(ref) = 2.46V - 2.55V in section 6 of the datasheet? There are no other thermal accuracies to account for since my thermal environment is enveloped by the qualification thermal range, correct?

Also, the SMD for this part state Vi(ref) = 2.46V - 2.54V. Is the TI datasheet or SMD correct?

7 months ago

+1 Andy Fondaw 7 months ago

TI__Intellectual 2160 points

Hi Kyle,

The V_I(ref)spec in the datasheet indicates the accuracy of the device feedback reference voltage.

This is also total device accuracy when at unity gain (V_KA=V_REF).

If V_KA is set to a higher voltage, the TL1431-SP is susceptible to other errors that may effect the overall accuracy beyond VREF. Section 9.2.4 "Total Accuracy" of the device datasheet states the following sources of error.

Thanks,

Andy

0 Sarah Koch 7 months ago

TI__Expert 8950 points

Hi Kyle,

In addition to Andy's comments, I will add that the SMD limits match the limits we test against so those should be considered correct. I have noted the discrepancy for the next datasheet revision.

Thanks,

Sarah

0 Kyle Ryan 7 months ago in reply to Andy Fondaw

Prodigy 10 points

Ok thanks. We are using it in a unity gain config, so this answers my question.

0 Andy Fondaw 7 months ago in reply to Kyle Ryan

TI__Intellectual 2160 points

Thank you for confirmation, Kyle.

I will close this thread now since your question has been answered.

Power management

Power management forum

TL1431-SP: Total Accuracy