Other Parts Discussed in Thread: BQ35100
Tool/software:
Hello I've calibrated the voltage for my bq35100 device wit open circuit load. It's within 10mV in the open circuit condition...but it's around 150mV when a load is used (aroud 250mA of current flowing)...Is this to be expected?
What is the expected accuracy?
As a side question. Our current board does not have the ability to drop the load current to zero for voltage calibration. Any issues with incrementing/decrementing the offset with current flowing to obtain the calibration..?
This would be accurate in the flow conditions but possibly off in the no-flow condition...thoughts?
