• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 101 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5036: LM5036 packaging pin issue

jeno.zhang
Expert 2635 points
Part Number: LM5036

Tool/software:

hi，

As shown in the figure below, there are no defined PADs at the four corners of LM5036. Are there any connections inside these four PADs? Can I connect to AGND?

Thanks！

  • 0
    TI__Mastermind 29825 points

    The corner pads are only for mechanical stability and can help improve accuracy for placing the IC during pick and place manufacturing. Recommendation is not to connect to AGND but just leave them on the PCB as unconnected floating NETs.

    Regards,

    Steve