RE: LM5170EVM-BIDIR: Low output voltage

Surabadin Daengdon

Thank you for your answer.

Today, I tested using an input voltage of 12V/10A and HV side connecting with R = 200 Kilo-ohms. However, the output voltage on the HV side was only around 24-25V. Is there anything problem? Thank you.
Best Regards

10 months ago

0 Feng Ji 10 months ago

TI__Mastermind 20245 points

Hi Surabadin,

Please check the jumper settings following https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1342854/lm5170-q1-question-about-lm5170-q1-evm/5115675?tisearch=e2e-sitesearch&keymatch=lm5170%252520jumper#5115675

The only difference is buck mode and boost mode.

Best Regards,

Feng

0 Surabadin Daengdon 10 months ago in reply to Feng Ji

Prodigy 40 points

Yes my jumper was corrected. thank you

+1 Feng Ji 10 months ago in reply to Surabadin Daengdon

TI__Mastermind 20245 points

Hi Surabadin,

Please share some waveforms like input voltage, output voltage, inductor current to know the status.

Best Regards,

Feng

+1 Surabadin Daengdon 10 months ago in reply to Feng Ji

Prodigy 40 points

Today, I tested using an external power supply, and the Boost mode is now working. it can boost to 50V with LV at 12V/10A and a load of 30 ohms on the HV side. Thank you for the advice.

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Power management

Power management forum

RE: LM5170EVM-BIDIR: Low output voltage