LP2951: "TOO FEW NODES" ERROR IN LTSPICE

Kreem Kasasbeh

Part Number: LP2951

Tool/software:

I am trying to simulate the LP2951-33DRGR using the model from your website with LTspice and I got a too few nodes error, when I checked the .lib file it seems to by encrypted, could you please provide me with an unencrypted model?

I would like to note that we already have bought LP2951-33DRGR and need to run some simulation for our design.

looking forward to hearing from you soon.

Best regards,

3 months ago

0 Ishaan Shetye 3 months ago

TI__Expert 6150 points

Hi Kreem,

Please share an email to which you'd like the unencrypted model be sent.

Best Regards

Ishaan

0 Kreem Kasasbeh 3 months ago in reply to Ishaan Shetye

Prodigy 10 points

Hi Ishaan,

Please, use this email

amkasasbeh@gmail.com

Thank you for your reply and support.

Best regards,

Kreem

0 Ishaan Shetye 3 months ago in reply to Kreem Kasasbeh

TI__Expert 6150 points

Done. You are welcome.

0 Kreem Kasasbeh 3 months ago in reply to Ishaan Shetye

Prodigy 10 points

Sorry Ishaan but I did not receive it could you please try again with this email

kreem.kasasbeh@lennox.com

0 Ishaan Shetye 3 months ago in reply to Kreem Kasasbeh

TI__Expert 6150 points

Kreem,

I am getting the below error when I try to send you the file. I tried sending both the zipped folder as well as the .lib file but both are not going through.

0 Kreem Kasasbeh 3 months ago in reply to Ishaan Shetye

Prodigy 10 points

sorry about that but it seems there are some restrictions on the email.
sorry again could you try to send it the first email again amkasasbeh@gmail.com I checked even the spam but I had nothing