The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

  • State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 167 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS62827: Do not leave enable pin floating ?

Ben Huang1
Intellectual 705 points
Part Number: TPS62827

Tool/software:

Sir

We are planning to make the TPS62827 on by enable pin only (VIN power up before EN high, EN is not sourced from VIN but from additional I/O power)

As mentioned in the datasheet, “Do not leave enable pin floating”

We intended to connect a pull-down resistor about 100kohm to EN to avoid floating in any situations.

Does it make any sense to connect a pull-down resistor?

Or what is your suggestion? If the EN floating is not allowed.

Thanks

Regards

Ben