This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPSM843A26: using BP5 to pull up PG to apply to subsequence power module EN pin

Part Number: TPSM843A26
Other Parts Discussed in Thread: TPSM843620, TPSM843320,

Tool/software:

Hi, I am using TPSM843A26, TPSM843620 and TPSM843320 to generate the necessary rails for a FPGA system, intend to use PG and EN to achieve the require sequencing, however for these series of power module, the PG and EN pin max voltage is 5.5V,  but my system input voltage is 12V, can I use the BP5 (internal LDO) as the pull up voltage as shown in below diagram ?