LM25117: Webench power Designer Simulation Failed

Reiner Frankenhauser

Part Number: LM25117

Tool/software:

Hello,

since a few days, every simulation with LM25117 failed.
What settings are necessary?
Regards Reiner

0 Dino Maslic 6 months ago

Hi Reiner,

Can you please give more information on what is failing in the simulation?

Thanks,

Dino

0 Reiner Frankenhauser 6 months ago in reply to Dino Maslic

Hi Dino,

if i start a simulation, i get this message:
Simulation Failed - Sim Type: Startup Sim ID: 21
Regards Reiner

0 Dino Maslic 6 months ago in reply to Reiner Frankenhauser

Hi Reiner,

The simulation runs fine on my end, what are you operating conditions for your design?

Thanks,

Dino

0 Reiner Frankenhauser 5 months ago in reply to Dino Maslic

Hi Dino,

today, it´s working.
Without any change...
I don´t know why.
So, i will try it a few times, with different components.

Thanks,
Reiner

+1 Dino Maslic 5 months ago in reply to Reiner Frankenhauser

Sounds good.

Power management forum