BQ25758: schematic review

Hi Jeff,

Thanks for working with this. I have reviewed the schematic. Here are my notes:

• There appears to be a typo on the net name for REGN going to DRV_SUP. Make sure this does not cause any disconnect issues so that DRV_SUP is powered.
• Also, it looks like DRV_SUP is being pulled to PGND by a 0 Ohm resistor. This would short REGN and DRV_SUP which would not allow the device to operate.
• This device requires a programming resistor on the pin 36 FSW_SYNC to program a switching frequency.
• IIN and IOUT (Pins 10 and 9) should not have a series capacitor. This looks like a filter network that a programming resistor should go in parallel to. These pins require a resistor from the pin to PGND.
• TS/NC (Pin 8) does not need the temperature sensing network unless you will set EN_TS = 1.

Regards,
Michael