• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 62 subscribers
  • Views 183 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS2543's Device Control Pin

Tsuguhiko Asai
Expert 1260 points
Other Parts Discussed in Thread: TPS2543

Dear All,

Please teach us setting of Device Control Pin of TPS2543.

When customer use DCP_Auto Mode, the setting of each CTL Pin is follows.

(CTL1,CTL2,CTL3)=(0,1,1)

(CTL1,CTL2,CTL3)=(0,0,1)

Please teach difference between (0,1,1) and (0,1,1).

Best Regards,

Tsuguhiko Asai

  • 0
    TI__Intellectual 2795 points

    Refer to Table 2. Truth Tabel, you can find there are 4 DCP_Auto

    (1) CTL1, CTL2, CTL3, ILIM_SEL=0010

    (2) CTL1, CTL2, CTL3, ILIM_SEL=0011

    (3) CTL1, CTL2, CTL3, ILIM_SEL=0110

    (4) CTL1, CTL2, CTL3, ILIM_SEL=0111

    (1) and (3) are same without load detection, (2) and (4) are similar with load detection, but the load detection have some difference, please refer to the notes (2), (3) below the truth table.

  • 0 in reply to Milo Zhu
    Expert 1260 points

    Dear Milo-San,

    Thank you very much for your kindly response.

    I understand these difference.

    Best Regards,

    Tsuguhiko Asai