Hi,
I am trying to use BQ24150 for charging. I get the software online (http://focus.ti.com/en/download/aap/DesignEnv/BQ2415xEVM-SW/publish.htm). I got everything connected, but always has the software saying "No USB Bridge attached"
I am sure my computer (64bit), the Micro USB cable, the USB Interface Adapter from TI, the 10 pin ribbon cable, the BQ24150 board are good ones, because I tried to download BQ24192's GUI online, and installed, and it indicated "USB Bridge connected" for the same setup!
I wonder if the software are an old version, or something else is wrong. Could somebody kindly answer my question?
Thanks and Regards,
Bo
