• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 64 subscribers
  • Views 374 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Lm2671(ADJ)

Alan Pugh
Prodigy 70 points
Other Parts Discussed in Thread: LM2671

Hello

I am thinking of using an LM2671 (adjustable output) to produce a battery charger powered by a solar panel.

Looking at the block diagram on page 8 of the data sheet it would seem to be ok to use the scheme shown in the

block diagram that (I think) I have included to protect both the LM2671 and the solar panel,   when the solar panel voltage falls below that of the battery ?

0435.BattCharge.pdf

  • 0
    TI__Genius 16025 points

    Hi Alan,

    I've received your request and will provide feedback on your schematic soon.

    Thanks,

    Anston

  • 0 in reply to Anston Lobo
    TI__Genius 15810 points

    Alan,

    This approach is fine. But you will have a fixed diode drop on your input and there will be that additional power loss because of that. You might want to have some circuitry that disconnects the solar panel when it's voltage falls below a threshold. A FET can be introduced in place of the diode and it can be driven in to saturation when you want the solar panel charging the battery.

    Regards,
    Akshay

  • 0 in reply to Akshay Mehta
    Prodigy 70 points

    Thanks Akshay

    Yes I realise that the diode will consume some energy so I am looking into using the LTC4412 + a P channel MOSFET  which will give a drop of about 20mV and also provide a status signal to a micro controller when the switch off happens.

    Regards

         Alan.