BQ24167's battery detection problem.

Yatin

Other Parts Discussed in Thread: BQ24167

Hi all,

I am facing strange problem with BQ24167. It's battery detection loop is getting un-stabilized. I have attached waveform for SYS voltage. It is constantly moving from 4.3V (no-battery) to 3.85 V. Surprisingly, the power good and charging signals are always low and not toggling.

When the charging source is removed the battey voltage is 3.75V and the system voltage is also 3.75V. What could be the problem ? Please let me know if any more details are required

over 9 years ago

0 Jeff F over 9 years ago

TI__Guru**** 152756 points

When source is applied, what is the voltage at the IC's IN or USB pin? What is the current capability of the input source? Can you measure input current and input voltage on the same plot as above.

0 Yatin over 9 years ago in reply to Jeff F

Intellectual 390 points

Hi Jeff,

I am attaching the voltage at USB pin v/s SYS voltage waveform. The input source current capacity is 1A. It is very difficult for me to plot input current on the scope. So, just attaching the Input voltage waveform.

Do you think this could be because of battery not attached properly ? I am facing this problem only in one board.

0 Jeff F over 9 years ago in reply to Yatin

TI__Guru**** 152756 points

The battery detect routine has a 250ms deglitch time. This is closer to 50ms -60ms. The TS deglitch time is 50ms. The deglitch time on SYS short circuit is 60ms. The input voltage is dropping below 4.5V for brief periods.

0 Yatin over 9 years ago in reply to Jeff F

Intellectual 390 points

Well noted. I will update you on further debugs.

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

BQ24167's battery detection problem.