LMZ13610EVAL mounting hole locations

bitumen

Other Parts Discussed in Thread: LMZ13610EVAL, LMZ13610, LMZ13610DEMO

HI,

Is TI able to provide a drawing for measurements of the mounting holes for the LMZ13610EVAL board? Or PCB files or something that can be measured in CAD software?

Thanks in advance,

Ben

over 9 years ago

0 Anston Lobo over 9 years ago

TI__Genius 16025 points

Hi Ben,

Are you referring to the mounting holes to prop the board above a work bench? If so the diameter of the Via is 1/8" and the total diameter including the copper pad is 5/16".

Thanks,
Anston

0 bitumen over 9 years ago in reply to Anston Lobo

Prodigy 30 points

Yes - those 4 holes.. I'm after the x and y locations from some sort of reference point? .. the diameter is excellent information - thanks for that.

We are planning to go this into a box and the mechanical engineer needs to know where to place the holes to screw into the plastic stand-offs or where to place metal ones.

0 Howard Chen-WEBENCH Design Center over 9 years ago in reply to bitumen

TI__Expert 6365 points

Here is the LMZ13610 EVM mounting holes locations (mils).

0 Mark Rodzinka over 7 years ago in reply to Howard Chen-WEBENCH Design Center

Expert 1105 points

Are the dimensions the same for the LMZ13610DEMO board?

They look the same, but are technically different products, form what I have seen. If the dimensions are different, are they available for the LMZ13610DEMO board? I haven't had any luck finding those either.

Thanks,
Makr

Power management

Power management forum

LMZ13610EVAL mounting hole locations