• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Subscribers 65 subscribers
  • Views 483 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM2585S-ADJ internal Ref

BOOPATHI KANNAN
Prodigy 20 points

Hi,

I need 24V  output but my input is 12V so that i chooses LM2585S, here i am getting the internal Ref is 0.6 only.

Can any one please give me the suggestion to solve this.

Thanks in advance.

  • 0
    TI__Genius 15810 points
    What is the exact nature of the problem? Where are you measuring 0.6V? Please send us your schematic.
  • 0 in reply to Akshay Mehta
    Prodigy 20 points
    i am using LM2585S-ADJ for converting 12V to 24V to drive a solenoid which rated current is 460mA, so that i have choosed this Circuit.
    But same circuit i have done in dot board but i not able to get 24V,on the pin to i am getting 0.6V voltage.There i need 1.2 for step up the output to 24V.
    Can you please help me to solve in this, also circuit in the data sheet. Page NO 19 and figure 49
  • 0 in reply to BOOPATHI KANNAN
    TI__Genius 16025 points

    Can you also take a picture of your bread board design and post it here? The recommended approach for designing a circuit is by using webench.

    I've attached a design here to compare with your circuit, Let me know if this fixes it.

    http://webench.ti.com/webench5/power/webench5.cgi?lang_chosen=en_US&VinMin=12&VinMax=12&O1V=24&O1I=.8&op_TA=30

    Boopathi E2E.pdf