Dear team,
One of our customers ( Avnet EMG, CERN) has the following questions about the reference design PMP9444.
http://www.ti.com/tool/PMP9444?keyMatch=PMP9444&tisearch=Search-EN-Everything
"
1. Where I can find XML files for Fusion Digital Power Designer for PMP9444?
2. I would like to use my board in system with 5V backplane but also 12V backplane and for VCCINT I need max. 10 A. It is possible to modify power solution for Kintex-7 Ultrascale FPGA in such way that Vin can be in range 4.5 -12.5 V? According to requirement VCCINT= max.10A , can I replace TPS40428 + 2x CDS95378 by LMZ31710 and such achieve range for Vin 4.5-12.5 V ?
3. Can you advice how to modify XML files for this replacement?
"
About the first question, I found on the forum the files that I have also enclosed to this post.
Could you please advice for the other questions?
Thank you very much for your support.
Best regards,
Massimiliano De Cristofaro
Application Support Engineer - Power Management
ASKTEXAS DiamondLane – EMEA Distribution Support
Texas Instruments Deutschland
