Using UCC24610 for Push Pull

takahiko yokota

Mastermind 7135 points

Other Parts Discussed in Thread: UCC24610

I have a question about UCC24610.

I seem to use this device for for LLC-Resonant Half-Bridge.

Can this device use Push Pull circuit?

Best regards,

Yokota

over 7 years ago

0 Peter Meaney over 7 years ago

TI__Mastermind 31580 points

Hi Takahiko-san,

The UCC24610 will be ok in a push-pull circuit. If you have used the UCC24610 then you know that the Vcc is limited to 5V typical and the Vd voltage is limited to 50V.

Regards

Peter

Power management

Power management forum

Using UCC24610 for Push Pull