Hi There,
Please could someone check over this schematic for me please and share any feedback?
Best regards,
Ross
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi There,
Please could someone check over this schematic for me please and share any feedback?
Best regards,
Ross
Hi Qian,
Typically automotive customers do not like to have resistor values above 100K on the board - leakage is a big concern along with dendritic growth. What would you advise here, taking the 100K max resistor value into account?
For C6422, do you have a figure in mind? I appreciate the advice re. the Bode plot, but wanted to speed this up for the customer if possible?
Best regards,
Ross
Hi Ross,
I was told by team that with 158ohm RLIM resistor, the OC threshold could be close to 10A.
If this OC threshold is too high for customer, please use the largest value allowed in the application for RLIM.
Thanks
Qian