LMR16006YEVM: Layout questions

Ruslan Gim

Part Number: LMR16006YEVM
Other Parts Discussed in Thread: LMR16006

Hi!

I am working with LMR16006Y first time, and I need help in assessing the correctness of the layout of the circuit. All parts were calculated according datasheet with output current less than 100mA.

over 8 years ago

0 Frank De Stasi over 8 years ago

TI__Guru* 76165 points

I think your schematic and layout are fair.

I have the following comments:

1. I would increase the value of C12/16 to 10uF

2. Need many more ground vias around C12/16, D4/5, C14/18 and the ground of the device. This will help to connect the grounds better.

3. Connect top of R3/6 closer to C12/16

4. Use as wide a trace as possible to pin2 ground.

0 Ruslan Gim over 8 years ago in reply to Frank De Stasi

Prodigy 150 points

Thanks a lot, Frank! Your comments are realy helpful.

0 Ruslan Gim over 8 years ago in reply to Frank De Stasi

Prodigy 150 points

Hi, Frank! I corrected my LMR16006 layour according your advices. Is it better now?

Power management

Power management forum

LMR16006YEVM: Layout questions