• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 65 subscribers
  • Views 577 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

REF3025: REF3025

Heini Moeckli
Prodigy 10 points
Part Number: REF3025
Other Parts Discussed in Thread: REF3012

What is the maximum capacitive load at the output of REF3025.

In the circuit are 10uF/X/R in parallel with 10nF/C0G. Is this ok?

Thanks

Heini

  • 0
    Guru 140200 points

    Hi Heini,

    section 9.1 of datasheet of REF3025 recommends an output capacitance of less than 10µ for REF3012. It's wise to follow this recommendation also for the REF3025. An additional 10n/NP0 in parallel to the 10µ/X7R isn't needed, usually. Connect the 10µ/X7R output cap directly to the chip.

    Kai

  • 0
    TI__Mastermind 19550 points

    Hi Heini,

    Kai referenced the correct section in the datasheet. The 10nF is not needed. Just make sure not to exceed 10uF with low ESR. The REF3025 is stable without  a capacitor.

    -Marcoo