Hello there..
I am right now working on BQ27742-G1 fuel gauge. i have made one simple programming code for I2C fuel gauge and controller (stm32l053c8). And also i use TENERGY li-ion 3.7v 1400mah for fuel gauge . and made one simple setup to discharge battery with connecting resistor in series so i can get value voltage at specific state of charge.
As battery discharge i can get new value of voltage but SOC(state if charge) does not update until i remove my battery and plug-in in socket.
so please give me suggestion why my soc is not update by itself when voltage update itself. is there i need to make any other configuration for this...
