BQ500211A: Chip can't generate a serial PWM signal

allen gao

Part Number: BQ500211A

hi:

I design the power transfer circult by the "Typical Low-Cost Application Diagram "circult on the page 20 of the datasheet.But the chip can not work normally.

The pin12,pini13 (DPWM-A,DPWM-B) can't generate a serial wave. It generates a short time PWM wave around every 6 seconds.I can't find the solution of the problem.

regards

over 5 years ago

0 Gautham over 5 years ago

TI__Genius 12475 points

Junkai,

Due to holidays, our response time is slower than usual. Someone from my team will get back to you shortly.

thanks!
Gautham

0 Bill Johns over 5 years ago in reply to Gautham

TI__Guru 65846 points

Hello Junkai
It looks like you are seeing an Analog Ping which is a low power pulse intended to detect if an RX is present, short pulse every 5 sec or so.
If the circuit detects an RX it will the send the 50% duty cycle digital ping. Unit is looking for change is amplitude of the Analog Ping of RX detection.

Due to holidays our response time will be slower than usual.

Power management

Power management forum

BQ500211A: Chip can't generate a serial PWM signal