• State TI Thinks Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 62 subscribers
  • Views 204 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Slew rate of LM2832

Takahiro Nishizawa
Genius 5575 points
Other Parts Discussed in Thread: LM2832

We have a question about LM2832.

Is there limit on input slew rate in EN pin?

If this IC has limit, please tell us the range of slew rate.

Best regards,

Takahiro Nishizawa

  • 0
    TI__Guru**** 191445 points
    Nishizawa-san,

    EN is a logic input. You should be able to drive it with any typical logic drive slew rate.
  • 0 in reply to JohnTucker
    Genius 5575 points
    Thank you for your answer!

    We have new questions.

    Does EN pin have hysteresis?
    Will not it happen that the IC repeats on / off when EN pin is started very slowly?

    Best regards,


    Takahiro Nishizawa
  • 0 in reply to Takahiro Nishizawa
    TI__Guru**** 191445 points
    Nishizawa-san,

    The datasheet is unclear about the actual circuit details. The Electrical Characteristics Table suggests that this is a digital input, but from experience, it may be that it is actually an analog input with or without hysteresis (ask me how I know...). I will need to check it in an actual circuit. I have ordered an EVM and will get back to you next week.
  • 0 in reply to JohnTucker
    TI__Guru**** 191445 points

    Nishizawa-san,

    I was able to secure an EVM to test.  It is as I suspected.  The datasheet specifies the EN start threshold as 1.8 V minimum and the EN shutdown threshold as 0.4 V maximum.  This is similar to how logic threshold for TTL logic are specified.  In actual measurement, the EN start threshold is about 1.18 V with about 50 mV of hysteresis, so teh EN shutdown threshold is about 1.13 V.  In between those voltages, the circuit may start and stop randomly.  I would ensure that my rise time for EN is much less than 1 msec and that the on and off values are within the range as specified in the datasheet.