• State Resolved
  • Locked Locked
  • Replies 6 replies
  • Answers 1 answer
  • Subscribers 65 subscribers
  • Views 346 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TLV703: Understand TLV703 output voltage accuracy!

dawei zhi
Prodigy 40 points
Part Number: TLV703

if the typical output voltage accuracy value 0.5% is guaranteed at room temperature with factory test?

  • 0
    Guru 285390 points
    No. Typical values are not guarantees.

    Please note that the power dissipation inside the device will heat it up, so even if a guaranteed 25 °C value existed, it would be pretty much pointless.
  • 0 in reply to Clemens Ladisch
    Prodigy 40 points
    Hi Clemens:

    Thanks for your reply.

    The load and input condition has been defined in the table as 10mA and Vin=Vout+2V. So the temperature rise will be small due to the loss in this conditoin. (0.01A*2V*254.1degree/W = 5 degree)

    In the datasheet, it say the typical value is 0.5% at room temperature, and the worst case is 2% with –40°C ≤ TJ ≤ 125°C. If you look at typical temperature varation in figure 5 is not anywhere near 1.5%. This make the typical curve in figure 5 pointless or the basic accuracy 0.5% is pointless. Am I wrong somewhere?

    BRs
  • 0 in reply to dawei zhi
    Guru 285390 points
    In the worst case, both the initial accuracy and the temperature variation might be worse than the typical values shown in the graphs.
  • 0 in reply to Clemens Ladisch
    Prodigy 40 points
    Thanks again for reply.

    0.5% typical is really not useful at all then. Don't understand why it is mentioned in the datasheet at the first place anyway. A distribution graphic with different batch woudl be helpfull.
  • 0 in reply to dawei zhi
    TI__Genius 10460 points
    Hi,

    Clemens is correct, the output accuracy is guaranteed max/min of +-2%, not the typical 0.5%. The initial accuracy and output variation over temperature for a given unit will vary but are guaranteed to be within +-2%. However, typical specs and characteristic graphs are measured and averaged in a bench setting, so they are useful in providing an idea of the general performance of the device.

    Figure 5 shows the output variation over temperature for a typical unit. The output rises by about one-fifth of a division to a maximum of 1.804 V over the recommended operating temperature. This corresponds to an output accuracy of (1.804 V - 1.8 V)/1.8 V * 100 = 0.22%, which is close to the typical accuracy spec.

    Thanks,
    Gerard
  • 0 in reply to Gerard Copeland
    Prodigy 40 points
    Thanks Gerard for the explanation.