LM3553: LM3553 Evaluation board GUI

Hyemin Kwon

Prodigy 70 points

Part Number: LM3553
Other Parts Discussed in Thread: LM3533, , USB2ANY

I bought a LM3553 Evaluation board.

But I could not find GUI.

Where can i download the GUI in TI site?

over 5 years ago

0 Kenneth Du over 5 years ago

TI__Genius 14295 points

Hi, Hyemin

Proper engineer has been assigned to take a look at this and will reply you soon.

Due to Chinese new year holidays, response maybe delayed.

Thanks for your understanding.

Regards,
Kenneth

0 Sean Zhou over 5 years ago

TI__Mastermind 22745 points

Hi Kwon,
You can download from below website: www.ti.com/.../toolssoftware
Regards
Sean

0 Hyemin Kwon over 5 years ago in reply to Sean Zhou

Prodigy 70 points

Thank you for reply, Mr.Zhou.

But the link you informed me is GUI of LM3533.

LM3553 is a LED Driver and I bought a LM3553SDEV.

Can you check again please?

0 Sean Zhou over 5 years ago in reply to Hyemin Kwon

TI__Mastermind 22745 points

Hi Hyemin,
I don't find this on Ti.com, but you can use a simple MCU to communicate with this device, this device only has several regs, it should be easy to do that. Thanks.
Regards
Sean

0 Hyemin Kwon over 5 years ago in reply to Sean Zhou

Prodigy 70 points

I'm not firmware engineer so it's too difficult to use this device right now.

In datasheet "TI has created an I2C compatible interface generation program".

I understand that if I buy LM3553SDEV, I can use program without any evaluation.

And TI had solved same issue by attaching program file when other customer requested the program about 3 years ago.

I try to use attached file but it is not working with my LM3553SDEV.

I guess the grogram version is old.

I need to work the evaluation board in a short period of time.

I wish TI provides software.

0 Sean Zhou over 5 years ago in reply to Hyemin Kwon

TI__Mastermind 22745 points

Hi Hyemin,
Yes, we have the USB2ANY , this tool can be used with several interface, this may help you, you can try to request form Ti.com:
www.ti.com/.../usb2any
Regards
Sean

0 Hyemin Kwon over 5 years ago in reply to Sean Zhou

Prodigy 70 points

Hi Sean Zhou.

I download USB2ANY Tool and try to work EVM board. But it doesn't solve my problem.

Do you have a program like attached picture?

0 Sean Zhou over 5 years ago in reply to Hyemin Kwon

TI__Mastermind 22745 points

Hi Hyemin,
No, this is the old version software, we don't support this software now. I think the simple way is to use a simple MCU to write a little code tocommunicate with device.I'm sorry.
Regards
Sean

Power management

Power management forum

LM3553: LM3553 Evaluation board GUI