• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 62 subscribers
  • Views 464 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC27211A-Q1: UCC27211

Hitesh Chandwani
Prodigy 210 points
Part Number: UCC27211A-Q1
Other Parts Discussed in Thread: CSD18535KCS, UCC27211

Dear Sir, 

I am using UCC27211 to drive the High side MOSFET CSD18535KCS. 

I am getting  peak to peak output Voltage which is equal to the input voltage to UCC , rather than getting the voltage equal to supply given to Drain of High Side MOSFET. I have used Bootstrap capacitance of 0.1uF. Is there any problem with the placing of Bootstrapping capacitor?

I have attached my PCB design.

  • 0
    TI__Mastermind 20950 points
    Hello Hitesh,
    The placement and routing of the bootstrap capacitor looks very good, with close placement and short trace connections. I do not see the connection from the UCC27211 HS pin to the high side MOSFET source and low side MOSFET drain. Can you confirm if that connection is in place, or if the driver is not driving a typical MOSFET half bridge, can you provide a schematic. The schematic can be simplified if desired.
    Please confirm if this addresses your question, or you can ask for additional information on this thread.

    Regards,
    Richard Herring