Hi teams
When the TPS 61029 is disabled, it generates about 60 ° C. Is it possible to generate such heat when disabled?
The power supply configuration is as follows.
The input voltage is 1.2 [V] (nickel metal hydride battery) or 5 [V] (USB) (supplied from a nickel metal hydride battery unless it is stuck)
The output voltage is 3.8 [V].
The current is about 33 [mA], and the setting of the IC sets the PS pin to LOW. (Connect to GND)
As a result of examination, the space between SW pin and GND is 10 ~ 12 [Ω], but it was about 400 Ω just after mounting on the board.
I would appreciate it very much if you could advise me anything.
Best regards
Hayashi