TPS62175: connection dot disappear on the design document

Shinichi Inoue

Guru 19701 points

Other Parts Discussed in Thread: TPS62175

Dear Specialists,

My customer is confirming TPS62175 by using WEBENCH and has a question.

I would be grateful if you could advise.

---

When I made a design file, connection point of the circuit disappeared.

The Simulation view is no problem.

I was wondering if you could improve.

---

I appreciate your great help in advance.

Best regards,

Shinichi

over 5 years ago

0 Omar Hegazi over 5 years ago

TI__Intellectual 1780 points

Hi Shinichi,

I am not aware of a way to keep the connection nodes in the exported design report using the report generation tool in WEBENCH. I will note this down as an improvement for the tool. In the meanwhile, the customers are able to export the design to almost any circuit/PCB design tool of their choice.
Many thanks for bringing this up!

Best regards,
Omar

0 Shinichi Inoue over 5 years ago in reply to Omar Hegazi

Guru 19701 points

Hi Omar,

Thank you for your reply.

I'll make the customer confirm other way you suggested.

Also, I am looking forward to waiting for the tool revised.

I appreciate your great help.

Best regards,
Shinichi

Power management

Power management forum

TPS62175: connection dot disappear on the design document