This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCD3138HSFBEVM-029: Matching Sample Project to HSFB Firmware

Part Number: UCD3138HSFBEVM-029
Other Parts Discussed in Thread: UCD3138


I am trying to utilize some of the features of the UCD3138, such as feed forward and current loop control. In the sample project  (Offline mode>UCDB31xx Isolated Digital Power Controllers > HSFB Center-Tap) when I click the 'Design' tab it shows me many features, as seen below.

However, when I connect the device flashed with stock firmware (, the program appears as follows:

Note the lack of parameters and tabs, such as Current Loop and Feed Forward Loop. The stock firmware also shows up with a project name of  'DC-DC BUCK'. If I try to load the project from the sample (the .xml), I receive an error.

The lines in question for the error above can be seen below

I have looked in the code of the stock firmware using Code Composer Studio, and it appears that Feed Forward is programmed in. The PMBus command, FA, is in there also. As such, I would assume that it would show up in the GUI. I have tried everything that I can think of to get this to work and I would very much appreciate any assistance.

Software: Code Composer Studio, and Fusion Digital Power Studio 3.0.36

Thank you