Hi All,
In the LM5110 datasheet, it says that pins 5 and 6 of the DPR package are "Not Connect". The term "Not Connect" does not tell me that I must leave the pin floating ("Do Not Connect") or that I could tie it to GND or any other signal ("Not Connected").
Q1) Are pins 5 and 6 of the LM5110-1SD bonded to the die internally ("Do Not Connect") or are they truly not connected ("Not Connected")?
Q2) Would it be possible for TI to standardize this description to either "Do Not Connect" or "Not Connected"? The term "No Connect" is too ambiguous for this purpose.
Cheers,
Casper van Doorne
Pink Fluffy Unicorns BV