REF6025: C_L value for load transient response graph on the datasheet

Hi Oba,

Let me look into this for you.

Hello Marco,

Thanks for your reply. OK, If CL = 10uF, I have an additional question.
I feel like that the transient response for 3mA, Figure 18, is not good. 

My customer is looking at both REF60xx and REF50xx.
I think REF60xx should have better transient response performance because it has very good reference buffer.

But comparing transient response between REF60xx and REF50xx,  REF50xx looks better for high current case.
The below is from REF50xx datasheet. Comparing REF50xx and REF60xx with 1mA case, REF60xx looks better.
But comparing REF50xx with 10mA and REF60xx with 3mA, REF50xx looks better.
Could you tell me the reason that REF50xx looks better for higher current case for transient response?

Regards,
Oba

HI Oba,

I am still investigating this question with my team. I will reply once I have an answer.