HI team,
How to make TPS794 output 1.2V, there is no description on how to configure R1 R2 and C1 when need output 1.2V. Could you help to share some comments?
Thanks.
Regards, Sunny
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Sunny,
In the datasheet, on Page 9, equation 2 provides R1 and R2 calculation and the table in Figure 23 also provides two examples for 1.8V and 3.6V outputs. Please let me know if you are having trouble finding the information.
Regards,
Jason Song
Hi Jason,
THansk for for comments, but for 1.2V output, as it`s same with REF, so is it just should output to FB, and then remove R2 and C1? we need your comfrim.
Thanks.
Regards, Sunny
Hi Sunny,
To get the reference voltage at the output pin, you may simply short FB to the Output, you don't need to put a resistor(R1) in between. So R1, R2, C1 all can be removed once FB is shorting to OUT.
Regards,
Jason Song