What is the "best practice" for unused PMBus pins? (PMB_CLK, PMB_DATA, SMB_ALRT#)
In the following post, the answer was "they can be left floating"
https://e2e.ti.com/support/power-management/f/196/t/711485?tisearch=e2e-sitesearch&keymatch=tps549d22%2520unused
But in this post, it was stated the Data and CLK pins can be tied to GND to help eliminate noise
https://e2e.ti.com/support/power-management/f/196/t/717231?tisearch=e2e-sitesearch&keymatch=tps549d22%2520no%2520PMBus
---> What about a 10kΩ pullup to the BP pin?
A little clarification would be much appreciated.
Thanks!
Darren