Dear Sirs,
I found the TPS62808 output voltage will higher than 1.8V if my output current is very low.(2mA)
As other E2E post, it seems the startup simulation is no problem.
However, the steady state simulation still have wrong output voltage.
Is this the short simulation time issue, too?
Hi Peter/Davor,
We have resolved the issue. I have attached the pdf for your reference. The issue was with simulation time as the device was entering PFM mode.
The changes will be updated on ti.com in our next production release. We will update you on it.
Thanks and Regards,
Atul
