UCC256302: after the burst operation

ACGUY

Part Number: UCC256302

Hello E2E,

In an individual, on the board using UCC256302, when the burst operation is exited, high side FET become to on at ISNS during fall down.

Please ket me know, is it normally? or malfunction?

e2e.ti.com/.../TI_5F00_Inquiry.xlsx

Regards,
ACGUY

over 4 years ago

0 Mike O' over 4 years ago

TI__Guru 72115 points

We have received your inquiry and are looking into it.

Regards,

0 Mike O' over 4 years ago in reply to Mike O'

TI__Guru 72115 points

Hello,

I believe what your are observing is the converter detecting zero current switching when it comes out of burst mode. The controller will adjust the gate drive signals and frequency until the converter is not zero current switching on the primary. I believe this is normal and should not cause any issues with the design.

Please refer section 6.13.14 ZCS Region prevention and figure 29, 39, 40 and 42. When ZCS switching is detected the SS voltage is pulled down through Rdischarge. This resistor should have been labeled RSSdown and is roughly 447 ohms.

If you relook at HO, LO, and Isns you will observe this is what is occurring. If this is not causing an issue with output voltage ripple, I would not make any adjustments to the design.

Regards,

0 ACGUY over 4 years ago in reply to Mike O'

Guru 11170 points

Hello,

Please let me know that why did not happen that operation on other device? I want to know reason that what different each device operation.

Regards,

ACGUY

0 Mike O' over 4 years ago in reply to ACGUY

TI__Guru 72115 points

Hello,

The difference may be due to resistor and capacitor tolerances on the VCR, LLC and ISNS pins.

Regards,

0 ACGUY over 4 years ago in reply to Mike O'

Guru 11170 points

Hello,

Thank you for reply.

I will suggest device swap between each boards to customer.

BR,

ACGUY

Power management

Power management forum

UCC256302: after the burst operation