• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 63 subscribers
  • Views 187 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS62410-Q1: Ripple voltage on 3.3V output

pavan kumar7
Prodigy 50 points
Part Number: TPS62410-Q1
Other Parts Discussed in Thread: TMS320F28377D, TPS62410, TMS320F28379D

Hi team,

I am pavankumar from Mahindra electric

I am using TPS62410-Q1 ic to supply the power to the MCU (TMS320F28377D).

both 3.3V and 1.2V outputs are present at regulator output.

But i am observing ripple with 0.25V on 3.3V output with 30KHz Frequency which is not appearing on 1.2V output.

Request you to support on this issue.

Thank you

  • 0
    TI__Expert 5415 points

    Hi Pavan,

    Which load did you connect during your testing?

    Best regards,

    Juergen

  • 0 in reply to Juergen
    Prodigy 50 points

    Hi,

    currently TPS62410  connected to TMS320F28379D MCU and for other peripherals.

    Can you confirm how much load i can draw from 3.3V and 1.2V in TPS62410 ic and is there any inductor and capacitor values required to change for load  variation.

    Currently expected current on board  3.3V is 300mA and 1.2V i am using only for controller.

    kindly support.

    Thank you.

  • 0 in reply to pavan kumar7
    TI__Genius 13440 points

    Hi Pavan,

    The typical external values are suggested in the datasheet like inductor 2.2uH and output cap min 22uF.

    Could you share the waveform of 3.3V rail where the ripple is observed and schematic? The 

    800mA load current can be drawn from the converter and the current drawn from the converter is inside specification.

    Best regards,

    Tanvee