CCS/UCD3138ACCEVM149: CCS debug with UCD3138ACCEVM149

Hitoshi Sugawara

Tool/software: Code Composer Studio

Hi Champs,

UCD3138FW_LLC is the CCS project file.
Is it possible to connect to the UCD3138ACCEVM149 and debug with CCS directly?
If it works, is it connect through JTAG with XDS or USB-to-GPIO?

Or can UCD3138ACCEVM149 be connected with USB-to-GPIO by utilizing Fusion Digital Power Studio?

Thank you for teaching me.
Best regards,
Hitoshi

over 3 years ago

0 Yitzhak Bolurian over 3 years ago

TI__Mastermind 18370 points

Hello Hitoshi,

You can use both CCS/JTAG/XDS and/or FUSION DIGITAL POWER/USB-to-GPIO to download the firmware and debug.

I personally like the use of FUSION DIGITAL POWER/USB-to-GPIO better.

Mainly because you can see the registers and variables with FUSION DIGITAL POWER/USB-to-GPIO at any time, without the need to stop the microcontroller and without the need for breakpoints.

Hope this helps.

Regards,

0 Hitoshi Sugawara over 3 years ago in reply to Yitzhak Bolurian

TI__Mastermind 18650 points

Hi Yitzhak,

Thank you for quick support.
Let me double check with you if XDS110 or XDS200 work with the UCD3138ACCEVM149?

Best regards,
Hitoshi

0 Yitzhak Bolurian over 3 years ago in reply to Hitoshi Sugawara

TI__Mastermind 18370 points

Hi,

XDS200 is not fully tested with UCD, XDS110 is fully tested and recommended.

Regards,

0 Hitoshi Sugawara over 3 years ago in reply to Yitzhak Bolurian

TI__Mastermind 18650 points

Hi Yitzhak,

Thank you for your confirmation.
It helps us.

Best regards,
Hitoshi

Power management

Power management forum

CCS/UCD3138ACCEVM149: CCS debug with UCD3138ACCEVM149