This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5161-Q1: Using flybuck design in webench

Part Number: LM5161-Q1
Other Parts Discussed in Thread: LM5161

Hello, I Am using a flybuck topology design for the main supply in my main design. While using webench power designer, I wish to change the transformer being used. While looking for alternatives I do see the parts I would like to try and  for each transformer  part number ,it gives me options for how I want to configure the transformer in terms of turns ratio between primary and secondary. (these are multi winding transformers). No matter which turns ratio I choose a turns ratio of 1:1 goes into the design which then change my secondary voltage, which I obviously do not want. Any suggestions?  thanks