TPS62260: Damage of internal low side MOSFET

Sadanori Kato

Part Number: TPS62260

Hi,

If the internal low side MOSFET is destroyed and the output terminal and GND are short-circuited, what are the possible causes?

Best regards,
Kato

0 Febin over 4 years ago

Hi Kato,

There are several reasons for the FET to get damaged.

Firstly, please check if the design is as per the datasheet recommendations.

Please ensure the recommended operating conditions are not violated.

If you can provide more details on the application like schematic, measurement plots, etc., it will be easier to debug.

Regards,

Febin

0 Sadanori Kato over 4 years ago in reply to Febin

Guru 36510 points

Hi Febin-san,

For the damage of internal low-side FET, could you please tell me the root causes which you have experienced in general terms?

Best regards,
Kato

0 Febin over 4 years ago in reply to Sadanori Kato

Hi Kato,

Please check if the Absolute maximum ratings given in the datasheet are exceeded. Please check for all pins especially at the SW pin.

Regards,

Febin

0 Sadanori Kato over 4 years ago in reply to Febin

Guru 36510 points

Hi Febin-san,

Thank you for your support.

I would like to share the screenshot during power-up with you via a private message. So, could you please accept my friendship request?

Best regards,
Kato

0 Sadanori Kato over 4 years ago in reply to Sadanori Kato

Guru 36510 points

Hi Febin-san,

Thank you for your approval.

I just sent the detailed information via a private message. So, please check it.

Best regards,
Kato

0 Febin over 4 years ago in reply to Sadanori Kato

Hi Kato,

Thanks!

Regards,

Febin

Power management forum