This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM25066: Connecting Pull up to external 3.3V other than VDD

Part Number: LM25066

Hi,

Im using LM25066 for hotswap application, where i want to put RETRY# into latch off mode. 

so i have made RETRY# to pull up with external 3.3V supply, is it ok to connect or we need to connect to VDD only which is coming out from LM25066.

i need same clarification on all strap and control signals.

1. RETRY, CB, CL, Power GOOD, SMBA, Address line and DATA/CLK lines.

Found issue after connecting RETRY# to external 3.3V, FET is showing dead short.

thank you,

Praveenkumar