LM3532: Possible to program the POR (Power On Reset) registers?

Leif Ilvedson

Part Number: LM3532

I want to use the LM3532 as a standalone chip. I would preprogram its POR registers so that it refers to those settings on power up.

Is this possible? My tests thus far suggest the POR registers are not being set.

The POR table on 7.6 in the manual:

0 Yuting Shao over 5 years ago

Hi Leif,

This device doesn't feature with EPROM, so preprogram is not available.

BR,

Robin

0 Leif Ilvedson over 5 years ago in reply to Yuting Shao

Ahhh...I see the mistake I made. I didn't realize that the POR column in Table 2 of the pdf was listing values, I thought those were addresses!

Thanks Robin.

Power management forum