Hello,
Following is our circuit to generate 3.3V from 5V. We are using a similar circuit to generate 1.2 and 2.5V also. The board is supposed to operate till -40 and so all the components chosen are of this range.
The problem is as follows:
1) The regulators operate fine as the temperature is lowered (till -25C)
2) However when the board is powered cycled (OFF only for even a second), lower than -10C the 3.3V regulator's output is noisy and stays around 1.95V.
3) Subsequently when the temperature is increased to a little more than -10C then the regulator becomes alright.
Please advise on what could be going wrong. The 1.2 and 2.5V regulators operate just fine and the loads are similar.
Thank you for your help in advance,