UCD3138A64: UCD3138A64 error #10010 and #10099D

Stefano Porrini1

Part Number: UCD3138A64
Other Parts Discussed in Thread: UCD3138

Hi,

I have compilated the LLCHBFirmware-1.2 to UCD3138A64 but i have two errors: #10010 and #10099D. The firmware wasn't changed from original. I adjusted the Designated code state from 16 to 32 and I cleaned the memory of CCS but not anything.

What is the problem? Can I resolve it?

Thank you

Best Regard

over 3 years ago

0 Yitzhak Bolurian over 3 years ago

TI__Mastermind 18370 points

Hi Stefano,

I understand that you compile the code for UCD3138A64.

Can you send a screen shot of the errors you get?

The code state should be set to 32 bit only for a few files in the project and not for the whole project.

What is the version of CCS you are using? What is the version of the TI ARM compiler that you are using (you can find this under project properties).

Regards,

0 Stefano Porrini1 over 3 years ago in reply to Yitzhak Bolurian

Prodigy 40 points

Hi Yitzhak Bolurian,

I'm using the CCS version 10.2.0.00009 and the compiler is TI v20.2.4.L TS.

0 Yitzhak Bolurian over 3 years ago in reply to Stefano Porrini1

TI__Mastermind 18370 points

Hi Stefano,

You do not need to uninstall your version of CCS.

But for use with UCD3138, please download CCS6 from the following link:

https://software-dl.ti.com/ccs/esd/documents/ccs_downloads.html

Install it and use TI ARM Compiler version "TI v5.2.4" for compilation.

The only files that need to be set to 32 bit mode are : interrupts.c, standard_interrupt.c, software_interrupt_wrapper.c, zero_integrity_word.c, clear_program_flash.c.

Hope this helps.

Regards,

Power management

Power management forum

UCD3138A64: UCD3138A64 error #10010 and #10099D